Categories

Hot Products

Knowledge

  • China is gradually moving from a mold-producing country to a die-manufacturing powerhouse.……
    May 17
    2018
  • According to the statistics of China Die and Mould Industry Association, since 2010,……
    May 17
    2018
  • The roughing strategy needs to be based on the type of blank and the condition of the mold profile.……
    May 17
    2018
  • China's mold industry continues to develop, but at the same time there are many problems that need to be solved. China’s mold industry has been busy expanding,……
    May 17
    2018
  • According to statistics, in the first half of 2013, the output of molds in Hubei Province was 16,388 sets, with a growth rate of 3.43%; of which,……
    May 17
    2018
  • According to the “National Basic Situation of Mold Specialized Plants” compiled by the Management Committee of the China Die and Mould Industry Association,……
    May 17
    2018
  • 1) Problems with the material of the main working part of the mold, improper material selection. Material performance is not good,……
    May 17
    2018
  • 1: After the mold is used for a long time, it must be sharpened. After grinding, the edge surface must be demagnetized, and it must not be magnetic,……
    May 17
    2018
  • In the selection of materials for molds, the principle of economy must be taken into account and manufacturing costs should be reduced as much as possible.……
    May 17
    2018
  • 1. Low density: The small plastic density is of great importance for reducing the weight and energy saving of mechanical equipment, especially for vehicles, ships, aircrafts, and space vehicles.……
    May 17
    2018
  • 1. Forgeability It has low resistance to hot forging deformation, good plasticity, wide forging temperature range,……
    May 17
    2018
  • QR CODE
  • facebook