Several situations that cannot be ignored when using an aluminum cutting machine
In industrial manufacturing and house decoration, the aluminum cutting machine is mainly used to cut various types of aluminum, because the aluminum it cuts is very flat and is loved by many users. However, there are many precautions when using an aluminum cutting machine. In this article, I will make a specific understanding.
1. Before using the aluminum cutting machine, the relevant operators must be very familiar with the performance of the cutting machine and be able to skillfully operate the cutting machine equipment. Two-handed operation is required when cutting aluminum, and one-handed operation of the machine is prohibited.
2. Before using the cutting machine equipment, we need to carefully check its various parts, check whether the outer casing is loose, whether the electrical wire is grounded, etc., only after ensuring that all parts can be used normally, can the cutting machine equipment be used for operation.
3. When using the aluminum cutting machine at night, it is necessary to have a sufficient bright environment, because the cutting gear on the cutting machine is very sharp, if it is a little careless, it will easily threaten the life safety of the operator.
4. Check whether there are sundries on the guide rail of the cutting machine for transporting materials. If there are sundries, they need to be cleaned up immediately, otherwise it will easily cause damage to the equipment if it enters the inside of the equipment.
5. Personnel should cut the discharge port of the machine, because there will be a lot of aluminum scraps splashing out of the discharge port, because the aluminum scraps are very sharp, and it is very easy to scratch the relevant personnel.
6. The cutting machine cannot be cut immediately after it is turned on. It needs to be put into an idling state. When the rotation speed of the gear reaches a certain requirement, the aluminum material can be cut. Because the motor has not been preheated before the equipment is turned on, and the equipment has not reached the optimal operating state, if the cutting operation is carried out at this time, it is easy to damage the main motor.
7. The aluminum cutting machine should be reserved for special personnel. Other personnel cannot use the cutting machine equipment without the consent of the relevant personnel.
8. Operators need to wear protective clothing when cutting aluminum. Because there will be a lot of dust and aluminum chips in the process, it will easily cause itching when it sticks to human skin. And there may be aluminum fragments at the feeding port of the cutting machine, which is easy to scratch the operator. Wearing protective clothing can effectively avoid this.
In the above content of the article, I have introduced eight points that need to be paid attention to when using aluminum cutting machine equipment. Keeping this information in mind can help everyone use the cutting machine equipment better. If you have any questions about this, please feel free to contact us, we will try our best to help you solve the problem.
English