The use of doors and windows is very common in modern society, and every household has them. With the rapid development of the construction industry, the use of doors and windows is also increasing rapidly. In order to meet the needs of buildings, the use of plastic steel doors and windows equipment The usage rate has also increased rapidly, so what tools will be used in the process of using this equipment? What kind of requirements will there be for cutting in the process of use? Let's see the introduction below.
Tools used in the use of plastic steel doors and windows equipment:
When running this equipment, it is necessary to use electric or pneumatic, manual screwdrivers, wooden hammers, rubber hammers, hand hammers, needle-nose pliers, flat-nose pliers, packing pliers, scribing needles, pens, electric drills, pneumatic drills, manual grinding wheels, etc.; fixtures Hand vices and bench vices are used in full; woodworking chisels, files, grinding wheel cutting saws, carbide cutting saws, hand cutting saws, etc. will be used for knives.
At the same time, it is also necessary to use special process equipment, such as drill molds, which are usually used to install hardware accessories to ensure the accuracy of the installation position. In the welding and screwing process, it is used to assemble lattice profiles or window sashes; positioning templates , It is mainly said that the shaped system also needs to configure special clamping and positioning templates and open window frames and fan positioning plates on the plastic-steel equipment sawing machine and welding plastic-steel equipment.
Requirements for cutting plastic steel door and window equipment:
In the production process of plastic steel doors and windows, there will be a professional process that is to cut grooves. This station accepts profiles sent from two stations, and cuts the profiles according to the technical requirements specified in the process documents, or cuts at both ends of the profiles. The grooves match each other, and their angles must be ninety degrees. In terms of door and window equipment, the cutting of the groove is carried out on the cutting saw of the plastic steel door and window equipment; when cutting, the doors and windows need to be made according to the cutting size on the design order.
The depth of the groove on the facet of the profile is half of the width of the facet during welding minus the welding allowance. After cutting, after the first inspection, a random inspection is required. After all the structures are cut by the plastic steel door and window equipment, the groove The angle difference should not exceed 0.3 mm; the depth difference of the groove should not exceed 0.5 mm; the verticality of the construction cutting surface and the two sides of the profile must be guaranteed.
English